If you find that the toe box is tight, use your thumbs to press and hold out the areas in the toe box of your boot while the boot is hot and pliable.Ĭ. Using the handle to apply pressure can help move the shell out to specific points.ī. Most skaters have made great use of a handled screw driver to push out the ankle bone while your boot is hot and pliable. Once your boot has completely cooled, repeat steps 18 for the other boot/frame.Ī. This is an important position to maintain during the molding process.ĩ. Your knee should be directly over your toes. While sitting, keep your hip and knee in line. Do not stand on the frame until your boot has completely cooled.Ĩ. Be sure to wear a sock during this process to protect your foot against the heat. While sitting in a chair, place the boot on your foot and lace your boots snug do not overtighten. Remove from oven with caution! Use hot pad or mitt to remove the boot and avoid contact with the frame and eyelets.ħ. If youre not satisfied with the pliability, check it every minute with a maximum of 10 additional minutes.Ħ. Check the oven after 10 minutes to see if the boot is pliable. Make sure not to let the boot or frame make contact with the heating elements.ĥ. Before putting your boot and frame in the oven, be sure to loosen the laces enough to easily slide your foot in the boot.Ĥ. Do not go beyond 200 degrees at any time for any reason.ģ. Turn on oven and set temperature to 175 200 degrees Fahrenheit. You should be able to move the frame from side to side when you apply pressure with your hands.Ģ. The frame should be snug on the boot, but not overly tight. information on the used material, as well as videos and other content about the product.1. There you will also find all the important specifications. Select the tab “Additional information” to find detailed information about this product. We recommend adding 5-9mm to your foot length, depending on how thick your socks are and how comfortable you want them to be. Choose a few millimeters more for more comfort.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |